ME0708 M-Stem Drive Kit

Be the first to review this product

Price as configured: $0.00

1 x Motenergy ME0708 PMDC Motor, 24-48V, 8 hp cont, 15 hp pk   +$449.00
1 x Alltrax SPM-48300 24-48V / 300A   +$348.00
1 x EZ-GO Pot Box   +$95.00
1 x Gigavac GV200QA-1 48V 500 Amp Contactor   +$129.00
1 x 6 AWG Wire Kit for Brushed Motor Drive Kit   +$50.00
1 x Fuse and Fuse Holder for Motor Drive Kit   +$30.00

* Required Fields

Motor

The ME0708 motor has the highest power/weight/dollar ratio available on the market for brushed PM motors. This motor is also a bolt-in replacement for the original Etek motor. The motor runs a little faster than the Perm and Lynch or Lemco motors.

- Brush-type Permanent Magnet DC motor.
- Light weight, high efficiency design.
- Designed for 24-48VDC battery operated equipment.
- 150 amps continuous at 48V (300 amps for 1 minute)
- Capable of 4.8 KW continuous and 15 KW for 1 minute.
- Totally open, fan cooled motor.
- Runs in either direction 

Power: 8 cont-- 15 pk hp 
Voltage: 48 Volt rated 
Speed: 3700 rpm @ 48V unloaded
Size: 8" OD, 5.5" long (w/o shaft), Shaft: 7/8"x 1-3/4", 3/16" key 
Weight: 28 lbs.

Controller

Choose from...

Alltrax AXE 4834 48V 300A 
Sigmadrive PM4825 48V 250A 4Q w/ Regen
Sevcon MillipaK 48V 300A 4Q w/ Regen

Throttle

Choose from... 

Magura Twist-Grip Potentiometer Throttle 
EZ-GO Pot Box Throttle 
Curtis PB-8 Pot Box Throttle

Contactor

Contactors (also known as solenoids) are used to connect and disconnect main battery buss power. When it is time to turn your vehicle on or off, the contactor will engage or disengage the power at the flip of a switch. This is very usefull in an emergency situation when main power needs to be turned off quickly and easily.

Alltrax controllers: If using an Alltrax controller, the contactor coil Voltage must match the nominal Voltage of your battery pack. It is highly recommended that an appropriate pre-charge resistor (included) and a coil spike suppression diode (included) be used with the contactor.

PG Drives Sigmadrive controllers:
If using a Sigmadrive controller, the contactor coil Voltage must match the nominal Voltage of your battery pack. It is highly recommended that an appropriate pre-charge resistor (included) be used with the contactor. A coil spike suppression diode is not necessary, so it is not included with Sigmadrive kits.

Sevcon controllers: At any nominal battery pack Voltage, Sevcon controllers use a 24V contactor by default. Pre-charge resistor and coil spike suppression diode are not necessary, so they are not included with Sevcon kits.

Wire Kit

Wiring kit specifically designed for this drive kit.

Fuse Block

Matching fuse and holder

Country of Manufacture

Only registered users can write reviews. Please, log in or register

For assistance with selecting the right components for your project, please use the appropriate form:

LVW Land Vehicle Worksheet
MCW Marine Craft Worksheet