Click on an image above to enlarge in a new window ^
Perm PMG-132 & Alltrax 7245
Motor Drive Kit
19Hp, 72v, 450Amp Electric Drive System
Includes:
Perm PMG-132 Motor
Alltrax 7245 Controller
Throttle (Twist-Grip or Pot Box)
Contactor w/ resistor & diode
Wire Kit
Fuse
Block & Fuse
Price:
Description
This is a 72v Perm PMG-132 & Alltrax 7245 electric motor drive kit by Electric Motorsport designed for electric vehicle builds, conversions, etc.
Kit Includes:
Perm PMG-132 Motor
PERM PMG-132 24-72 Volt Pancake Motor. Similar in size and weight to a Briggs & Stratton ETEK, but at the same voltage it has a 50% higher peak power output, a 40% higher torque constant and 120% more stall torque. The PMG 132 is a "pancake" style neutrally-timed, brushed, permanent magnet DC motor manufactured by Perm Motor in Germany. It is similar in design to the Lynch/LEMCO LEM-200 and Briggs & Stratton ETEK motors but more powerful. The armature is made of flat copper strips stacked together so there's no stack of steel laminations like in a traditional motor which gives the motor low cogging. Its high power, high efficiency and comparably small size make it a good choice for small electric vehicles, Electrathon vehicles, generators, go-kart's and robots.
Alltrax AXE 7245 Controller
24-72 Volts/450 amp
Size: 6-1/2" L x 5-3/4" W x 2-4/5" T
Throttle 0-5k Ohm
EZ-GO "Pot Box" Potentiometer (Curtis PB-6 Style Pot box throttle)
Size: 4-3/4" x 4" x 2"
OR
Magura Twist-Grip Potentiometer Throttle
Fits onto a 20-22 mm standard diameter tubular handlebar
Contactor
Contactors (also known as solenoids) are used to connect and disconnect main battery buss power. When it is time to turn your vehicle on or off, the contactor will engage or disengage the power at the flip of a switch. This is very usefull in an emergency situation when main power needs to be turned off quickly and easily. It is highly recommended that an appropriate pre-charge resistor (included) and a contactor coil suppression diode (included) be used with any contactor system.
Wire kit
Electric Motorsport wire kit specifically designed for the Perm PMG-132 Kit.
=
Fuse and Holder
Electric Motorsport fuse block
Size: 5" x 1-5/8" x 1-5/8"
