Downloads
Motor
The ME1003 is a brush-type, permanent magnet DC motor with very high efficiency. Capable of 11.5 KW continuous and 23 KW for 1 minute. For voltages from 12 to 72 VDC input and 200 amps continuous (400 amps for 1 minute). Designed for battery operated equipment. For more information, see the Performance Information section. Motor weight of 39 pounds. This motor has similar performance to the Lynch, Lemco, and AGNI motors
Power: 11.5 kW cont-- 23 kW pk
Voltage: 12-72 Volt rated
Current: 200A Continuous, 400A Peak
Speed: 3700 rpm @ 72V unloaded
Size: 8" OD, 7.4 " long (w/o shaft)
Shaft: 7/8"x 1-3/4", 3/16" key
Weight: 39 lbs.
The ME1008 is a Brush-Type, Permanent Magnet DC motor with very high efficiency. The ME1008 is a totally enclosed version of the ME1003. Capable of 6.4 KW continuous and 20 KW for 30 seconds (at 72 VDC). For voltages from 12 to 72 VDC input and 100 amps continuous (300 amps for 1 minute). Designed for battery operated equipment. Motor weight of 39 pounds.
Running these motors at voltages and/or currents outside of the manufacturer's ratings will void the limited warranty.
Controller
Choose from:
SR48300
SR48400
SR48500
SR48600
SR72300
SR72400
SR72500
Throttle
Choose from:
Curtis style PB-6 or PB-8 Pot Box Throttle
FP-6 style Foot Pedal
Domino Twist Grip throttle
Magura Twist Grip Throttle
0-5 kΩ Potentiometer Dial with Scale
Single Lever Marine Throttle (right or left hand)
Dual Lever Marine Throttle
Contactor
Contactors (also known as solenoids) are used to connect and disconnect main battery buss power. When it is time to turn your vehicle on or off, the contactor will engage or disengage the power at the flip of a switch. This is very usefull in an emergency situation when main power needs to be turned off quickly and easily.
When using an Alltrax controller, the contactor coil Voltage must match the nominal Voltage of your battery pack. It is highly recommended that an appropriate pre-charge resistor (included) and a coil spike suppression diode (included) be used with the contactor.
Switches
Choose from:
On/Off Ignition keyswitch with 2 keys
On/Off Toggle Switch - for Run Switch or Personality Mode Switch
Inertia Crash Sensor Switch
Emergency Disconnect Switch
Wire Kit
Wiring kit specifically designed for this drive kit.
Fuse Block
Matching fuse and holder
Add an optional Reversing Contactor if needed
Availability | No |
---|---|
Country of Manufacture | United States |
For assistance with selecting the right components for your project, please use the appropriate form:
Land Vehicle Worksheet | |
Marine Craft Worksheet |