- Current measurement up to ±350A (1000A tests pending)
- Accuracy: 0.5% (<350A)
- Resolution: 0.1A (<80A); 0.3A (>80A)
- Supply voltage 5.0 VDC
- Galvanic isolation 1kV
- Current consumption 25mA
- Wire lengths: 30cm, 60cm, 100cm, 150cm
- Dimensions: 103 x 35.9 x 21.2 mm
- Mounting holes: M10
EMUS BMS Bus Bar Dual Range Current Sensor is a highly accurate hall-effect current measurement device, specifically designed to be used in EMUS battery management system. Hall-effect based measurement method provides galvanic isolation, allowing the sensor to be placed between any two cells in a series-connected battery pack.
Specifications
Recommended for use with prismatic cells.
Standard cable length is 100cm, but the following lengths may be special ordered:
150cm, part # CS013A-150
60cm, part # CS013-60
30cm, part # CS013A-30
18cm, part # CS013A-18
Or, no cable, part # CS013A (only order this if it a replacement unit and you have the cable)
Availability | In Stock |
---|---|
Country of Manufacture | Lithuania |
For assistance with selecting the right components for your project, please use the appropriate form:
Land Vehicle Worksheet | |
Marine Craft Worksheet |